Available at www.Target.com

Models 84062 and 84063

ATOMIC CLOCK
MODEL 84062/84063
INSTRUCTION MANUAL

Thank you for your purchase of this quality clock. The utmost care has gone into the design and manufacture of your clock. Please read these instructions and store them in a safe place for future reference.
FEATURES
 Large LCD Time Display
 Super Accurate Atomic Time using the WWVB Radio Signal from the USA Atomic Clock
 Automatically adjusts the time each day
 Displays Month, Date, Day of Week
 Optional 12 Hour or 24 Hour (Military) Time Display
 Displays Room Temperature in Celsius or Fahrenheit
 Four Time Zone Setting (choose from Pacific Time, Mountain Time, Central Time and Eastern Time)
 Automatic adjustment for Daylight Savings Time in the Spring and Fall
Battery Insertion / Replacement
Note: For best performance, battery should be replaced at least once a year to maintain the best running accuracy. Ensure that the battery used is new and the correct size. Clean the battery contacts and also those of the device prior to battery installation.
 Begin by opening the battery compartment cover on the back of the clock and place 1 new AA alkaline (not included) into the compartment as indicated by polarity (+, -). CAUTION: Be sure to insert the battery in the correct position (+, -) when the battery is changed. the clock will be in set up mode for the Atomic reception.
Atomic Signal Reception
 IMPORTANT PLEASE NOTE: the clock will not operate or set for the first four minutes after inserting the battery. During this time the clock will be searching for the Time Signal from Fort Collins, Colorado and the setting functions will not operate. This is normal and not a defect in your clock.
 While the clock is searching for the Atomic Signal the WAVE button can be pressed to stop the search for the time signal.
 If you are in a location where it is difficult to receive the signal, the clock can be set manually and then it will automatically update to the correct Atomic time when it receives the signal. Normally, signal reception is best at night. If the signal is not received in the first four minutes, it is recommended you set the time manually and wait for the clock to catch the signal at night.
 Once the time is set (either automatically or manually), the clock will seek out the radio signal daily to keep its accuracy.
PLEASE NOTE: Scrolling tower means the clock is searching. Solid tower means the clock did not catch the signal. Solid tower with WAVE OK means your clock has caught the signal in the last 24 hrs.
Daylight Saving Time
 If you live in an area that does observe DST, place the DST switch into the ON position. The Letters DST will appear on the display next to the Atomic Signal ICON confirming you are in the Daylight Saving Time mode. The clock will now adjust automatically each spring and fall to correct for the 1-hour time change.
 If you live in an area that DOES NOT observe Daylight Saving Time (DST), slide the DST switch on the back of the clock to the OFF position to deactivate the DST function.
To enhance the Radio Signal Reception
 Do not place the clock too close to household appliances such as Televisions, computers, speakers, VCR’s and Fax Machines.
 Do not place on top of or close to metal surfaces.
 Do not place in a metal or concrete building unless close to a window with the curtains or other window treatment open.
 Do not use inside of a moving vehicle.
NOTE: RADIO SIGNAL RECEPTION MAY BE BLOCKED BY
 Mountains and valleys
 Tall buildings
 Power plants, power lines or high voltage cables
 Freeways and Airports
 Construction Sites
 Traffic Lights
 Neon Lights
 Bad weather between your location and the Atomic Clock in Colorado
Setting the Calendar
 Slide the SELECTOR BAR to the CALENDAR SET position. The main display will switch to the year and will flash.
 Using a pen or sharp in instrument, press the YEAR/12/24/SEC button to advance to the correct year.
 Press the MONTH/HR button to advance to the correct month.
 Press the DATE/MIN button to advance to the correct set date.
 The Day display will adjust automatically. If the day displayed is not correct, check to see you are in the correct YEAR.
 When finished, place the SELECTOR BAR in the LOCK position.
Setting the Time Manually
 Slide the SELECTOR BAR to the TIME SET position. The time display will flash.
 Press the MONTH/HR button to advance to the correct hour.
 Press the DATE/MIN button to advance to the correct minute.
 When finished, place the SELECTOR BAR in the LOCK position.
 When setting the time in the 12-hour mode, an AM or PM will appear on the display. AM and PM are only visible in the 12 hour display
Using the 12 or 24 Hour Display
Use a pen to press the YEAR/12/24/SEC button to toggle between the 12 or 24 –hour display. AM and PM are only visible in the 12-hour display.
Temperature Feature
Use a pen or sharp instrument to press the C/F button to select either Celsius or Fahrenheit temperature display.
Care of Your Clock
 Replace the battery promptly when necessary or store the clock without a battery when not in use.
 A soft cloth or a paper towel may be used to clean your clock. Do not use any corrosive cleanser or chemical solutions on the clock.
 Keep the clock clean and dry to avoid any problems.
 Avoid putting the clock in a highly humid environment, such as poolside or in a bathroom.
 Do not expose the clock to direct sunlight or extremely hot or cold temperatures.
 Please help in preservation of the environment and return used batteries to an authorized depot.
Remove the battery from the clock if you do not intend to use for an extended period of time.
 
TWO YEAR WARRANTY (U.S.A.)
Equity products are warranted for two years from the date of consumer
purchase against defects in material and workmanship. During this period
such defects will be repaired, or the product will be replaced at Equity's option,
without charge. This warranty does not cover damage caused by misuse or
negligence. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED
TO IMPLIED WARRANTIES OR FITNESS AND MERCHANTABILITY,
ARE LIMITED IN DURATION TO THE PERIOD ENDING ONE YEAR FROM
THE DATE OF PURCHASE. Some states do not allow limitations on how long
an implied warranty will last so the above limitation may not apply to you. This
warranty gives you specific legal rights and you may have  other rights which
vary from state to state.
 
If your clock isn't working, send it with a letter explaining the problem and $5.00 for postage and handling to: Customer Service Dept, Equity Industries Corp., 5721 Bayside Road Virginia Beach, VA 23455 U.S.A
   
Equity Industries Corp.
5721 Bayside Rd
Virginia Beach, VA 23455
For Customer Inquiries:
www.skyscaninfo.com
Email: This e-mail address is being protected from spambots. You need JavaScript enabled to view it